for Sep - Oct 7 or more recent firmware
Press control or touch screen for menu
2/4 limit for aa/ch firmwareTRACE
enable if off, else goto OFF/SINGLETRACE 0
OFF
disable other tracesSINGLE
enable if off, else goto OFF/SINGLETRACE 1
OFF
disable other tracesSINGLE
{4-trace firmware only}
enable if off, else goto OFF/SINGLETRACE 2
OFF
disable other tracesSINGLE
{4-trace firmware only}
enable if off, else goto OFF/SINGLETRACE 3
OFF
disable other tracesSINGLE
FORMAT
LOGMAG
PHASE
not implementedDELAY
SMITH
SWR
MORE
POLAR
LINEAR
SCALE
position trace vertically NUM KEYS
touch nanoVNA screen below menu to launch numeric keypad;
click hyperlink for numeric input discussion
REFERENCE POSITION
touch below menu to launchNUM KEYS
compensate CAL by e.g. cable length in picoseconds ELECTRICAL DELAY
touch below menu to launchNUM KEYS
select port to measure;
works for 2 and 4 trace firmwareCHANNEL
CH0 REFLECT
CH1 THROUGH
with 2 markers enabled, marker 2 will read DELTA Frequency in relation to marker 1SELECT MARKER
MARKER 1
MARKER 2
MARKER 3
MARKER 4
ALL OFF
increase minimum sweep frequency
to selected markerSTART
decrease maximum sweep frequency
to selected markerSTOP
shift center of frequency sweep
to selected markerCENTER
sweep frequency between 2 current markersSPAN
set sweep or single frequencySTIMULUS
sweep lower limit > 50kHzSTART
touch below menu to launchNUM KEYS
sweep upper limit < 900mHzSTOP
touch below menu to launchNUM KEYS
(START+STOP)/2CENTER
touch below menu to launchNUM KEYS
STOP-STARTSPAN
touch below menu to launchNUM KEYS
50 kHz < constant < 900mHzCW FREQ
touch below menu to launchNUM KEYS
freeze data collection;
click hyperlink for saving frozen data via USBPAUSE SWEEP
press RESET to clear data before calibrating.
Make appropriate [dis]connections before touching associated buttonCALIBRATE
OPEN
SHORT
attach 50 Ohm load to TX portLOAD
attach a 50 Ohm load to each portISOLATION
connect SMA cable[s] between portsTHRU
DONE
SAVE 0
SAVE 1
SAVE 2
SAVE 3
SAVE 4
press to clear data before CALIBRATERESET
toggle calibration
on / offCORRECT
DISPLAY+MARKER +STIMULUS+CAL settings RECALL SAVE
RECALL
RECALL 0
RECALL 1
RECALL 2
RECALL 3
RECALL 4
SAVE
SAVE 0
SAVE 1
SAVE 2
SAVE 3
SAVE 4